IERC BUMPER EXTENSION TABS SCX/ELEM/410 SLIDERS the bed sits flat on

the bed sits flat on the Empire 6x6 rails for a clean

providing strength and durability without unnecessary weight

IF NOT OPEN THE TRANSMISSION AND ARRANGE YOUR GEARS

these sliders use the older 3D-printed mounting block system

IERC BUMPER EXTENSION TABS SCX/ELEM/410 SLIDERS the bed sits flat on4 PIECE EXTENSION TABS 1 8" POWDER COATED STEEL WILL ALLOW YOU TO EXTEND THE FRAME 2. 55" FROM THE EDGE (ADD EXISTING BUMPER LENGTH) THE MOUNTING TAB CAN BE RAN UPWARD OR DOWNWARD TO RAISE OR LOWER THE BUMPER BY 0. 22" THE EXTENSION TAB CAN BE CUT TO LENGTH IF NEEDED. NOTE: HARDWARE NOT INCLUDED HARDWARE USED IN THE PHOTOS ARE x4 m3x12mm SCREWS & x4 m3 NYLOCK NUTS ADDITIONAL HARDWARE WILL BE REQUIRED TO HOLD THE EXTENSION PIECES TO THE FRAME.